THE BUILD BENCH
Parts & equipment
Know what to print, what to buy and what still needs checking.
Choose your model for materials, hardware quantities and component references. Each page identifies fit samples and optional parts separately from the airframe.
0.2 + M1
Bolt PWC
Printed skins, plywood and carbon reinforcement.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
0.3 + M1
Bolt PC
Printed structure with carbon reinforcement.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
L2 + M1
Transport 1829 PC
Four motors, two batteries and a rear cargo ramp.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
v 0.2 + v 0.2.1 tail-fit alternatives
Drift 420
A hand-launched glider with printed connections.
View equipment list ↗Glide fault unresolved — fit and balance investigation only.
v 0.1
Breeze 400
A simple, entirely printed biplane glider.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
v 0.2 rubber-only
Wisp 560
Rubber power with a printed propeller and shaft.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
L1 + magnetic canopy
Zephyr 900
A small powered glider with a magnetic canopy.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
v 0.10 full airframe, 17 plates
Relay 1200 P
A printed push-pull twin without carbon tubes.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
v 0.2
Meadow 620
A compact trainer with 17 printed parts.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
F3
Spire 750
Tall printed rocket with revised sliding fits.
View equipment list ↗Cold-fit model. Not cleared for launch.
v 0.4
Scout 490
A compact printed rocket.
View equipment list ↗Cold-fit model. Not cleared for launch.
v 0.3
Roll 530
Printed fittings around a paper-towel body tube.
View equipment list ↗Cold-fit model. Not cleared for launch.
v0.1
Skiff 170
A compact quadcopter with one integral frame, a removable battery deck and two landing skids. Four printed pieces, with purchased motors and propellers.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
v0.4
Rotor 235 canopy
A printed helicopter chassis with dimensioned KST servo carriers, an adjustable tail-boom clamp and a sliding motor-pattern fixture. Includes selected NX8-compatible controls, nine fit samples and arranged print plates.
View equipment list ↗Unpowered mockup — motor and rotor interfaces unfinished.
v0.1
Tern 1100
Printed flying boat, high tractor motor and side floats.
View equipment list ↗Fit-test prototype — hardware and physical build validation incomplete.
These lists follow the current local model packages. A listed component is not a flight or launch certification. Check the model’s status and outstanding choices before ordering.